-@subsection Manual Binary Package Installation
-
-Pre-compiled, binary packages can be installed in either a system
-package directory (this is determined when XEmacs is compiled), or in
-one of the following
-subdirectories of your @file{$HOME} directory:
-
-@example
-~/.xemacs/mule-packages
-~/.xemacs/xemacs-packages
-@end example
-
-Packages in the former directory will only be found by a Mule-enabled
-XEmacs.
-
-XEmacs does not have to be running to install binary packages, although
-XEmacs will not know about any newly-installed packages until you
-restart XEmacs. Note, however, that installing a newer version of a
-package while XEmacs is running could cause strange errors in XEmacs;
-it's best to exit XEmacs before upgrading an existing package.
-
-To install binary packages manually:
-
-@enumerate
-@item
-Download the package(s) that you want to install. Each binary package
-will typically be a gzip'd tarball.
-
-@item
-Decide where to install the packages: in the system package
-directory, or in @file{~/.xemacs/mule-packages} or
-@file{~/.xemacs/xemacs-packages}, respectively. If you want to install
-the packages in the system package directory, make sure you can write
-into that directory. If you want to install in your @file{$HOME}
-directory, create the directory, @file{~/.xemacs/mule-packages} or
-@file{~/.xemacs/xemacs-packages}, respectively.
-
-@item
-Next, @code{cd} to the directory under which you want to install the
-package(s).
-
-@item
-From this directory, uncompress and extract each of the gzip'd tarballs
-that you downloaded in step 1. Unix and Cygnus cygwin users will
-typically do this using the commands:
-
-@example
- gunzip < package.tar.gz | tar xvf -
-@end example
+@node Which Packages, Removing Packages, Automatically, Installing Packages
+@comment node-name, next, previous, up
+@cindex which packages
+@cindex choosing packages
+@heading Which Packages to Install:
+This is difficult to say. When in doubt install a package. If you
+administrate a big site it might be a good idea to just install
+everything. A good minimal set of packages for XEmacs-latin1 would be