-\1f
-File: lispref.info, Node: Edebug Execution Modes, Next: Jumping, Prev: Instrumenting, Up: Edebug
-
-Edebug Execution Modes
-----------------------
-
- Edebug supports several execution modes for running the program you
-are debugging. We call these alternatives "Edebug execution modes"; do
-not confuse them with major or minor modes. The current Edebug
-execution mode determines how Edebug displays the progress of the
-evaluation, whether it stops at each stop point, or continues to the
-next breakpoint, for example.
-
- Normally, you specify the Edebug execution mode by typing a command
-to continue the program in a certain mode. Here is a table of these
-commands. All except for `S' resume execution of the program, at least
-for a certain distance.
-
-`S'
- Stop: don't execute any more of the program for now, just wait for
- more Edebug commands (`edebug-stop').
-
-`<SPC>'
- Step: stop at the next stop point encountered (`edebug-step-mode').
-
-`n'
- Next: stop at the next stop point encountered after an expression
- (`edebug-next-mode'). Also see `edebug-forward-sexp' in *Note
- Edebug Misc::.
-
-`t'
- Trace: pause one second at each Edebug stop point
- (`edebug-trace-mode').
-
-`T'
- Rapid trace: update at each stop point, but don't actually pause
- (`edebug-Trace-fast-mode').
-
-`g'
- Go: run until the next breakpoint (`edebug-go-mode'). *Note
- Breakpoints::.
-
-`c'
- Continue: pause for one second at each breakpoint, but don't stop
- (`edebug-continue-mode').
-
-`C'
- Rapid continue: update at each breakpoint, but don't actually pause
- (`edebug-Continue-fast-mode').
-
-`G'
- Go non-stop: ignore breakpoints (`edebug-Go-nonstop-mode'). You
- can still stop the program by hitting any key.
-
- In general, the execution modes earlier in the above list run the
-program more slowly or stop sooner.
-
- When you enter a new Edebug level, the initial execution mode comes
-from the value of the variable `edebug-initial-mode'. By default, this
-specifies `step' mode. Note that you may reenter the same Edebug level
-several times if, for example, an instrumented function is called
-several times from one command.
-
- While executing or tracing, you can interrupt the execution by typing
-any Edebug command. Edebug stops the program at the next stop point and
-then executes the command that you typed. For example, typing `t'
-during execution switches to trace mode at the next stop point. You can
-use `S' to stop execution without doing anything else.
-
- If your function happens to read input, a character you hit
-intending to interrupt execution may be read by the function instead.
-You can avoid such unintended results by paying attention to when your
-program wants input.
-
- Keyboard macros containing Edebug commands do not work; when you exit
-from Edebug, to resume the program, whether you are defining or
-executing a keyboard macro is forgotten. Also, defining or executing a
-keyboard macro outside of Edebug does not affect the command loop inside
-Edebug. This is usually an advantage. But see
-`edebug-continue-kbd-macro'.
-